Login Register

1998 V70 Gas Door Topic is solved

Post Reply
User avatar
flyingswede
Posts: 30
Joined: 09 Jun 2009, 18:15
Year and Model: V70AWD 1998
Location: Virginia

Post by flyingswede »

I have replaced the plunger for the gas door. I know it works I can hear it, also replaced the hinge but he door will not open. It seems like there is not enough spring tension to push the door away from the plunger. Any ideas. Thanks for any help

User avatar
Clemens  
Posts: 1956
Joined: 03 Sep 2015, 12:34
Year and Model: 96 855 R + 94 855 T5
Location: Austria
Has thanked: 500 times
Been thanked: 228 times

Post by Clemens »

Will it open with the emergeny release behind the rear quarter panel cover? If yoyu get it open that way try spraying the locking mechanism with WD 40. Ever since I did that my fuel door has never been stuck again
1996 855 R,
black on black, M56 swapped, Quaife, TME 2.5 exhaust, 17 inch Volants

2010 V70 D5,
Saville Gray on tan leather, 18 inch Odysseus

User avatar
flyingswede
Posts: 30
Joined: 09 Jun 2009, 18:15
Year and Model: V70AWD 1998
Location: Virginia

Post by flyingswede »

Yes I can open with the emergency release, but I have to push on the front of door to open. It's almost like the spring is pushing to the closed position.

cn90
Posts: 8363
Joined: 31 Mar 2010, 09:54
Year and Model: 2004 V70 2.5T
Location: Omaha NE
Has thanked: 4 times
Been thanked: 504 times

Post by cn90 »

- Then get a new fuel door spring, it is cheap.

- On the same topic, my electric motor sometimes (5% of the time) does not work when I hit the switch on driver's door.
Sometimes car is driven by my kids/wife, so I make it easy for them by installing an emergency pull in the trunk, WITHOUT having to remove the side carpet trim. Here is how I do it:

* Undo the release mechanism (3 Torx screws, IIRC).
* I used RED electrical wire (the solid copper wire used in household wiring).
* One end wrapped around the tip of the electric motor, the other end sticking into the TRUNK (with a loop to pull).
This way when I can't open the fuel door, all I have to do is open the trunk and pull on the RED wire, no need to peel off carpet trim.
* It is a 10-min mod.


FuelDoor.jpg
FuelDoor.jpg (64.33 KiB) Viewed 1172 times
2004 V70 2.5T 100K+
2005 XC90 2.5T 110K+

scot850
Posts: 15508
Joined: 05 Apr 2010, 14:46
Year and Model: 2000 V70 R
Location: Calgary, Alberta, Canada
Has thanked: 2211 times
Been thanked: 1852 times

Post by scot850 »

When you replaced it did you use a 850 or a V/S70 mechanism as they are different. The 850 will fit but does not have the plunger that pushes the door cover out. 850 just removes a pin but you have to manually open the door after that.

Neil.
2006 V70 2.5T AWD Polestar tune
2000 V70 R - still being an endless PITA
2006 XC70 - Our son now has this and still parked in our garage
2003 Toyota 4Runner V8 Limited
2015 Kia Sportage EX-L - Sold
1993 850 GLT -Sold
1998 V70 XC - Sold
1997 Volvo 850 SE NA - Went to niece in California - Sold
2000 V70 SE NA - Sold

User avatar
flyingswede
Posts: 30
Joined: 09 Jun 2009, 18:15
Year and Model: V70AWD 1998
Location: Virginia

Post by flyingswede »

I got the V/S70 mechanism. I did order another hinge, but it sure feels the same. I will install tomorrow. Thanks for all the ideas.










i

User avatar
flyingswede
Posts: 30
Joined: 09 Jun 2009, 18:15
Year and Model: V70AWD 1998
Location: Virginia

Post by flyingswede »

Gas door solved. I was being to critical with the alignment. Plunger was not able to push the door open. Thanks for all the advise.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post