Login Register

P0027 and intermittent noisy top end

Help, Advice, Owners' Discussion and DIY Tutorials devoted to the second generation C70, S40 and V50 Volvos -- awkwardly model year 2004 ½ onwards -- plus where to go for advice and discussion on Volvo's sporty C30 Coupe powered by Volvo's ubiquitous inline 5-cylinder power plant.
Post Reply
Hyeloque
Posts: 2
Joined: 11 February 2018
Year and Model: s40 t5 2005
Location: QC

P0027 and intermittent noisy top end

Post by Hyeloque »

Hi there, I'm new to this forum and I'm seeking help as I'v been unable to find any solution to my problem, searched the whole web looking for answer though I was unsucessfull. I Have a 2005 s40 t5 with the b5254t3 engine and it seams that for about 5 minutes after my car as reached operating temp i get eccessive valvetrain noise, now this was a bit concerning but now I also got a p0027 exhaust valve solenoid. I'm leaning towards a light oil starvation on the top end. I'v had the camcover serviced so it might be that the guy who actually did it put on too much anaerobic sealant, thus blocking the oil passageways but before I dive in and redo it I want your feedback as I also heard of O rings in the oil pan going bad.

User avatar
RickHaleParker
Posts: 7129
Joined: 25 May 2015
Year and Model: See Signature below.
Location: Kansas
Has thanked: 8 times
Been thanked: 958 times

Post by RickHaleParker »

Check Oil pressure and quality first.

Possible source
  • Low oil pressure
    Poor engine oil quality.
    Sticking reset valve.
    Mechanical fault in the variable valve timing (VVT) unit.
⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000.
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0.

Hyeloque
Posts: 2
Joined: 11 February 2018
Year and Model: s40 t5 2005
Location: QC

Post by Hyeloque »

Oh yess i'l mention it now the oil is brand new and I ran an engine flush beforehand also I swapped the reset valve with a known good, i'l check my oil pressure tomorow

Post Reply
  • Similar Topics
    Replies
    Views
    Last post