-99 S80 T6 got BAD after Sacer TPS

[pnilz]

So I decided to replace the TPS in my ETM because it was throwing a P0121 code after some driving and would occasionally go into limp home mode. The mounting went good I think and now when I start it the triangle and emissions light comes on with the ignition on. I start it as normal and it goes good for a couple of seconds before starting to shake horribly. If I try to push the gas pedal it doesn't go over 1200rpm. Still throwing a P0121 code.

[pnilz]

Still have no clue why It doesn't work. I've connected it and checked voltages on the pins and its at 0.5V at fully closed, 1.2V at idle open and 4.5V on fully opened. When I turn on the ignition it just sits there, and when I shut it off it moves to fully closed for 5 seconds before going back to idle position.

EDIT: Heres a video showing how it runs.

[pnilz]

Hopefully final reply in this thread. I took the car to a dealer to reload the etm software and now it runs like a charm.

[Thyandyr]

Where did you buy your TPS for the ETM and which workshop you used?