Pulled a rear axle this weekend doing a bearing, lotta work. I'd at least try doing it the easy way first.cn90 wrote: ↑Mon May 21, 2018 9:58 pm - Now I wonder if I should grease the CV Joints "in situ".
- This is what I am thinking:
* Remove the wheel.
* Jack stand under subframe.
* Leave the axle in place.
* Undo the larger Oetiker clamps on both Inner and Outer joints.
* Add grease.
- Re-install the Oetiker clamps (using new clamps).
Has anyone done this (adding grease in situ)?
If it gets stuck having a slide hammer on hand is very useful. And pry bars.