How to replace the red seatbelt release button

Post by **yair** » 27 Oct 2018, 15:34

Just replaced the seat release buttons on my 1996 855.
These red buttons starts to break after 15-20 years of use, typically the front ones, as they get the most use.

Didn't find a thread that describes the procedure, so here it is:

You can get replacement buttons from IPD
https://www.ipdusa.com/products/5513/11 ... cle-button

Or you can get them easily from a junkyard, the back seat buttons are identical to the front seats, and often do no see a lot of use, especially on sedans.

The buttons are held in place by a tab on each side and can be popped out with a small, flat screwdriver.

To release, push a screwdriver tip between the button and the black holder, and then twist the tab a bit outward, until it is released, repeat on other side.

Note that there is a small spring that pushes the button upward, you don't want to loose it.

To install, push the red button down until it clicks into place.

Post by **abscate** » 28 Oct 2018, 07:21

Some of these seatbelts have electrical connections to the SRS in which case be careful you don’t break a connection with the barttery connection.

The dealer tax to reset a SRS is $150

Post by **rspi** » 28 Oct 2018, 12:16

Post by **rguzz** » 31 Oct 2018, 08:24

Thanks, my drivers looks like yours did.

Post by **polskamafia mjl** » 16 Nov 2018, 04:59

This is great! I've been dealing with a hole in my driver seat button for a few months now.

lilanlan · Post by **lilanlan** » 17 Nov 2018, 02:18

Thanks for sharing, it makes me a lot.