1994 850 N/A Manual won't start

Post by **abscate** » 07 Apr 2019, 18:41

Pull off the cap and rotor and clean them up and get a good spark

If you get a good spark and it won’t fire on ether, part it out or get a new engine

Aheadbeyond · Post by **Aheadbeyond** » 07 Apr 2019, 18:47

Didn’t mention this. New cap and rotor was the first thing I did. Gapped all the plugs at .028 and had good spark on all 5

Post by **RickHaleParker** » 07 Apr 2019, 21:47

Aheadbeyond wrote: 07 Apr 2019, 16:56 Pulled spark plugs put some stater fluid in. Didn’t even sputter.

You spray starter fluid in Air intake not the cylinders. By the time you get the plugs back in and the wires reconnected the starter fluid would be long ago dissipated.

Spray a three second burst of Starting fluid in the Air Intake hose, then crank immediately before the Starting has a chance to dissipate.

Post by **misha** » 08 Apr 2019, 07:07

This ^^^.

Aheadbeyond · Post by **Aheadbeyond** » 08 Apr 2019, 09:08

I tried this on my initial no start condition. I tried thru the spark plugs because it was suggested on an older post for a no start. I did spray it into the cap and poured it. But I will follow the suggested procedure now that I have gapped all the plugs to spec.
Just to verify.028? They were all at .040

Wanted to say thank you to everyone for their help.
Troy

Post by **abscate** » 08 Apr 2019, 10:54

0.028 inches , correct