Radiator fan runs continuously
-
BryonTheCanadian
- Posts: 22
- Joined: 09 Jan 2019, 13:47
- Year and Model: 2006 XC70
- Location: ON
- Has thanked: 4 times
- Been thanked: 2 times
Hi team my rad fan is now running on high from the second i switch on the car cold... If read it could be a defective part on the fan unit or high pressure switch on AC condenser... My Ac does not seem to be working so could be that.. Is there an easy way to disable the high pressure sensor to remove it from the equation? to see if its the Fan electronics... or other ideas B
- RickHaleParker
- Posts: 7195
- Joined: 25 May 2015, 14:30
- Year and Model: See Signature below.
- Location: Kansas
- Has thanked: 8 times
- Been thanked: 977 times
1. Disconnect the wire to the A/C clutch so that it cannot be engaged.BryonTheCanadian wrote: 23 Apr 2019, 11:23 Is there an easy way to disable the high pressure sensor to remove it from the equation?
2. Pull the wires on the A/C pressure switch and put a jumper across the two wires. 1/2 of a paper clip makes a good jumper.
3. Tape it so it does not get shorted.
If the fan runs correctly you found the source of the problem and can run this way until you get the A/C fixed.
Active
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2017 Ford PIU. 3.5l, Twin Turbo, 365 Hp.
............................
Past
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000. ( Killed by a plastic radiator. )
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion ( I moved, the project did not )
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0. ( Transmission dead after sitting for a winter )
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2017 Ford PIU. 3.5l, Twin Turbo, 365 Hp.
............................
Past
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000. ( Killed by a plastic radiator. )
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion ( I moved, the project did not )
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0. ( Transmission dead after sitting for a winter )
-
BryonTheCanadian
- Posts: 22
- Joined: 09 Jan 2019, 13:47
- Year and Model: 2006 XC70
- Location: ON
- Has thanked: 4 times
- Been thanked: 2 times
No have not checked much out. seems it could be 1 of two things either Fan switch or high pressure sensor on AC
-
BryonTheCanadian
- Posts: 22
- Joined: 09 Jan 2019, 13:47
- Year and Model: 2006 XC70
- Location: ON
- Has thanked: 4 times
- Been thanked: 2 times
Thanks Rick where would the AC pressure switch be located... ThanxRickHaleParker wrote: 23 Apr 2019, 11:401. Disconnect the wire to the A/C clutch so that it cannot be engaged.BryonTheCanadian wrote: 23 Apr 2019, 11:23 Is there an easy way to disable the high pressure sensor to remove it from the equation?
2. Pull the wires on the A/C pressure switch and put a jumper across the two wires. 1/2 of a paper clip makes a good jumper.
3. Tape it so it does not get shorted.
If the fan runs correctly you found the source of the problem and can run this way until you get the A/C fixed.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 26 Replies
- 4190 Views
-
Last post by abscate
-
- 3 Replies
- 1915 Views
-
Last post by Earn_est_89
-
- 2 Replies
- 1148 Views
-
Last post by Earn_est_89
-
- 8 Replies
- 5700 Views
-
Last post by oragex
-
- 5 Replies
- 1386 Views
-
Last post by abscate






