would a bad maf or dirty maf cause it not to start, only sometimes?
Dan
Still Crank No Start. Very Strange
-
goldmandan
- Posts: 244
- Joined: 5 June 2013
- Year and Model: 1999 S 70, 2000 V70
- Location: Florida
- Been thanked: 1 time
- abscate
- MVS Moderator
- Posts: 35275
- Joined: 17 February 2013
- Year and Model: 99: V70s S70s,05 V70
- Location: Port Jefferson Long Island NY
- Has thanked: 1500 times
- Been thanked: 3810 times
Possible but I would say rarely. You can disconnect it, then try (the car will run on a rmp/fuel map in software if there is no MAF signal)goldmandan wrote: ↑09 Jul 2019, 07:31 would a bad maf or dirty maf cause it not to start, only sometimes?
Dan
You will have to clear MAF code after that.
Dont unplug/plug MAF with ignition on, shut everything off.
Empty Nester
A Captain in a Sea of Estrogen
1999-V70-T5M56 2005-V70-M56 1999-S70 VW T4 XC90-in-Red
Link to Maintenance record thread
A Captain in a Sea of Estrogen
1999-V70-T5M56 2005-V70-M56 1999-S70 VW T4 XC90-in-Red
Link to Maintenance record thread
-
goldmandan
- Posts: 244
- Joined: 5 June 2013
- Year and Model: 1999 S 70, 2000 V70
- Location: Florida
- Been thanked: 1 time
i read ecm2400 is a short to ground in the wire from ecm to cem. Would make sense as the fuel pump relay was replaced already and i just put a new one in. no change. And the CEM does have a yellow wire going to starting/charging system. I think i may have found the culprit as the ecm2400 triggers right after i erase it and crank again.
-
- Similar Topics
- Replies
- Views
- Last post






