leak detection pump location

gwahlenberg · Post by **gwahlenberg** » 07 Aug 2019, 20:17

I need to replace the leak detection pump on my 07 volvo s40 and can't not find it's location on the vehicle.
Can someone help me locate it please

Post by **MoVolvos** » 07 Aug 2019, 21:33

What is a leak detection pump?

gwahlenberg · Post by **gwahlenberg** » 08 Aug 2019, 07:48

code P2402 evaporative emission system leak detection pump control circuit high

Cees Klumper · Post by **Cees Klumper** » 12 Aug 2019, 00:05

It's probably just a pump, and the error message is 'leak detection'

Post by **RickHaleParker** » 12 Aug 2019, 01:11

MoVolvos wrote: ↑07 Aug 2019, 21:33 What is a leak detection pump?

Think leak down test for the Evap system.

Post by **MoVolvos** » 12 Aug 2019, 20:12

RickHaleParker wrote: ↑12 Aug 2019, 01:11
MoVolvos wrote: ↑07 Aug 2019, 21:33 What is a leak detection pump?
Think leak down test for the Evap system.

Thanks, I googled it to see what it looks like.

So this pump is for the sole-purpose of self-diagnostic of the Evap System?
Is it creating pressure at all times?

Post by **MoVolvos** » 12 Aug 2019, 20:17

gwahlenberg wrote: ↑08 Aug 2019, 07:48 code P2402 evaporative emission system leak detection pump control circuit high

Not sure if you found it?

GR-372945 - Same parts diagram for both the 2.4 & 2.5. Part #8. I'm not familiar with the Evap System so I could tell either way its location.
https://www.volvopartswebstore.com/show ... evel=24658

Post by **MoVolvos** » 12 Aug 2019, 20:18

Cees Klumper wrote: ↑12 Aug 2019, 00:05 It's probably just a pump, and the error message is 'leak detection'

Thanks.

gwahlenberg · Post by **gwahlenberg** » 26 Aug 2019, 17:50

I found it. It is in a very hard place to get to. The bracket that holds it in place seems to be welded to the frame of the car. I was barely able to take the screws off. Now having hard time trying to take part off. I even tried to bend the bracket but it is not going anywhere... This car is a pain.

Cees Klumper · Post by **Cees Klumper** » 27 Aug 2019, 15:42

Sometimes people loosen engine mounts and jack up / tilt the engine, or remove other components, just to get better access, not sure that would help in this situation.