Login Register

Wrong spark plugs?

Post Reply
Teeka56
Posts: 10
Joined: 17 Nov 2019, 20:33
Year and Model: 2009 C30 T5
Location: Seattle

Post by Teeka56 »

Checked with dealer, it takes the 26mm reach plug. It had been running for quite awhile with short plug!

Still have misfire, moving coils to isolate which one is suspect.

Thanks for your help!

User avatar
pgill
Posts: 813
Joined: 27 Aug 2018, 17:42
Year and Model: 2010 S80, 2008 LR2
Location: California
Has thanked: 120 times
Been thanked: 189 times

Post by pgill »

If it were me I would try using the Denso TT plugs

Denso (4704) IKH20TT

I switched to Denso TT plugs for my Audi 2.0T because the Denso Plugs worked so well in my two Volvo engines

The idle and throttle response with the TT plugs is so much better.

Based on my research the big advantages of the TT (twin Tip) plug are the resistance to quenching the flame and the consistency of flame initiation.

One consideration is the heat range.

For Denso a higher number indicates a plug that can handle higher temperatures

If you are getting misfires is it during wide open throttle climbing a hill or is it at idle?

A high load misfire may require a colder (higher number then 20) spark plug

A misfire at idle or while cruising is a perfect candidate for the IKH20TT

Check the data when the miss fire was detected using an ODBII code reader

Good luck

Paul

Teeka56
Posts: 10
Joined: 17 Nov 2019, 20:33
Year and Model: 2009 C30 T5
Location: Seattle

Post by Teeka56 »

This car was idling on 3 cylinders. The scan tool said 4,5 were misfiring. Replaced plugs and now only 4 is misfiring. Moved coil to 2, and now 2 is coming up ( P0302).

I will check those plugs out for my C30 T5. I had used in the past on watercooled VW’s a WR7DTC- triple electrode. I was surprised at the difference at idle/throttle response as you noticed too.

User avatar
RickHaleParker
Posts: 7195
Joined: 25 May 2015, 14:30
Year and Model: See Signature below.
Location: Kansas
Has thanked: 8 times
Been thanked: 977 times

Post by RickHaleParker »

Teeka56 wrote: 20 Nov 2019, 13:35 Moved coil to 2, and now 2 is coming up ( P0302).
Before you toss the coil, try cleaning it's electrical connection. Also the metal pad under the bolt is a ground, make sure it is clean.
Active
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2017 Ford PIU. 3.5l, Twin Turbo, 365 Hp.
............................
Past
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000. ( Killed by a plastic radiator. )
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion ( I moved, the project did not )
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0. ( Transmission dead after sitting for a winter )

chrism
Posts: 1351
Joined: 28 Jan 2009, 09:38
Year and Model: S80 / 2005
Location: Atlanta, GA
Has thanked: 7 times
Been thanked: 89 times

Post by chrism »

A handy little tool for these situations is a simple little thing called a Grip Scale. It’s a crochet hook looking thing that measures the depth of a hole and is usually marked in 1/16” or 1/32” increments. It may also be available in mm - I’m not sure.

https://www.usatco.com/item/GRIP%2BSCALES/Grip-Gauges/

Post Reply
  • Similar Topics
    Replies
    Views
    Last post