removal of sepentine belt 2009 s60

volvomadness · Post by **volvomadness** » 23 Dec 2019, 16:45

Trying to removal the serpentine belt of 2009 s60. I have done these on 2005 and lower but not on a 2009. Don't see where to put the tool in for the tensioner, Is there a plastic cover on the tensioner?

If so how do it get the cover off

Thanks Madness

Post by **vtl** » 23 Dec 2019, 17:18

It can be either torx hole or the hex nut on the bearing. I've had both types of tensioners.

Post by **oragex** » 23 Dec 2019, 18:41

If there's a black plastic cover, put against its side a long flat screw driver then give it a small smack with your fist (I've simply used a long piece of pipe), it should jump off & no need to put it back. If you're going for the hex bolt, you need a ratchet slim enough to fit by the car frame. For the tension, you'll need a long handle, an extendable ratchet is the best - also toss the power steering reservoir - if you also lift the coolant reservoir, undo first the electrical connector underneath or it may damage the level sensor

Post by **RickHaleParker** » 23 Dec 2019, 22:34

: 09S60Sepentine.jpeg (60.85 KiB) Viewed 346 times

OR

: 09S60Sepentine2.jpeg (53.2 KiB) Viewed 346 times