Clutch replacement

NitroVolvo · Post by **NitroVolvo** » 07 Jan 2020, 15:59

Thanks,

I'm looking into the Alldata subscription now!

Post by **abscate** » 07 Jan 2020, 17:46

I’ll add this on this job.

It’s about 10 hours including all those other things that you do in there. I broke it up over two weekends and two days each weekend for 2-3 hours.

First prep, struts off prep car for engine drop

Second. Subframe drop engine drop, engine trans separation.

Third rework clutch , reconnect engine / transmission

Fourth Finalise and clean up

Post by **abscate** » 09 Jan 2020, 07:23

I am going to add to this.

When I did my P2, I found a hybrid of the Dual mass Flywheel and non-self adjusting clutch. This was stock build from the Ghent factory.

So, I would hold off ordering parts until you get the thing apart and see what parts you have

NitroVolvo · Post by **NitroVolvo** » 09 Jan 2020, 11:16

Does the Alldata service provide info on what else I can be doing while I have everything out?

Post by **abscate** » 09 Jan 2020, 12:30

It has procedures for most everything but you have to come up with the list yourself

Clutch
Pressure plate
Flywheel resurfacing..
Rear enginecoil seal
Transmission oil seal
Release bearing

Clutch replacement

Re: Clutch replacement