Torque spec for rear hub bolts. Topic is solved

jeffsws · Post by **jeffsws** » 29 Jan 2020, 11:12

Hello.

Do you know the torque spec for bolt 987377. I couldn't find anything on vida.

: Image credit: xHeart; MVS_0475a.jpg (481.35 KiB) Viewed 5555 times

Cheers
Jeff

Richard99 · Post by **Richard99** » 29 Jan 2020, 12:09

Autozone procedure lists 49 ft/lbs + 60 degrees. I would always be slightly suspicious of these though. I know that the front hub mounting bolts on S/V70s 98-00 are 33 ft/lbs +60 degrees, per this forum.

https://www.autozone.com/repairguides/V ... 52801c1485

jeffsws · Post by **jeffsws** » 29 Jan 2020, 13:46

Thank you.

I think hub might have been the wrong word to use. I guess that means wheel bearing in most cases? The wheel bearing on the rear is not held on by any bolts, other than the axle nut.

The bolts I mean are holding the actual wheel axle section. Part 9157713/9157714

jeffsws · Post by **jeffsws** » 10 Feb 2020, 13:20

Any ideas on the spec? Or just very tight and then a bit?

Post by **abscate** » 11 Feb 2020, 04:33

I see lower torque in Alldata, 35 Nm and 60 degree angle

Note that new hardware is also specified.