MAP Sensor location Topic is solved

Post by **RickHaleParker** » 25 Feb 2020, 01:09

To do pictures click on Full editor (below) and use the picture functions.
You can attach the picture or link to one hosted on another website.

MALL240 · Post by **MALL240** » 25 Feb 2020, 01:19

Maybe if we found de rubber tube that go connected to the manifold?? in your program? Can´t find it..

Post by **RickHaleParker** » 25 Feb 2020, 01:30

MALL240 wrote: 25 Feb 2020, 01:02 My engine is B230F

When I search with a B230F configuration, the part number does not come up. No engine pressure sensors come up for a B230F configuration. B230K configuration ... yes as shown above.

MALL240 · Post by **MALL240** » 25 Feb 2020, 01:42

OKKKKKKKK that's it. thanks a lot RIck!! I was going mad... i will return the piece... maybe my idle problem and hesitasion acceleration only in stopto run its from the regulator pressure ... its expensive, i will going to check if it clean and dry...

Thanks a lot guys!!!

Post by **RickHaleParker** » 25 Feb 2020, 01:45

MALL240 wrote: 25 Feb 2020, 01:19 Maybe if we found de rubber tube that go connected to the manifold?? in your program? Can´t find it..

Not that much detail.

B230F or B230FT (Turbo) ?

MALL240 · Post by **MALL240** » 25 Feb 2020, 01:55

B230F NO turbo

Post by **RickHaleParker** » 25 Feb 2020, 02:58

If you have a lot of kilometers on the car keep this in mind. A replacement fuel regulator does not need to last forever, it just needs to out last the car. You can get after market fuel regulators for about € 50.00 .

MALL240 · Post by **MALL240** » 25 Feb 2020, 03:02

Hi, yes.. i look in the rubber vacuum tube and its tottaly clean and dry... i believe its ok...

93Regina · Post by **93Regina** » 25 Feb 2020, 11:36

: Capture.JPG (91.23 KiB) Viewed 1741 times

MALL240 · Post by **MALL240** » 26 Feb 2020, 02:08

Hi, thanks for answering. You mean the MAP is on top of the MAF, inside that piece? Does the MAP component come out on a B230F?

What a mess.