Login Register

1995 850 T5 -- Clogged Drain Causes Serpentine Belt Slippage

Post Reply
User avatar
atucker1
Posts: 56
Joined: 21 Mar 2015, 16:34
Year and Model: 1995 850 Turbo
Location: Washington
Has thanked: 11 times
Been thanked: 15 times

Post by atucker1 »

Interesting little problem I had, might help anyone else if they have this weird issue too:

After extensive rains here, I had my 1995 850 Turbo parked on a steep slope. When moving from the spot, a few times I momentarily had all the dash lights illuminated and loss of power steering--signs of serpentine belt failure. Checking the hood, though, the belt was still there and after driving for a few minutes on a flatter road the issue went away. The belt is in good condition and was replaced only 30k miles ago.

Later that day, I checked the drain tubes along the top of the firewall--one was plugged, allowing a large amount of water to accumulate in the plastic panel below the windshield on the passenger side. I hypothesized that this water had sloshed onto the serpentine belt when I had pulled out of the parking spot on the hill and made the belt slip. Seemed weird to me, but the most reasonable explanation. I cleaned out the drain tube and the problem didn't occur again, even when pulling out of the same parking spot in the rain.

A few weeks later, I was washing my car and accidentally splashed water up under the hood. Right after that I had the exact same issue, with power steering going out and all the dash lights going off for a minute, and then no issues at all since.

Still seems like a weird explanation to me, but at least based on the two times it happened its been consistent. I would figure the water might be shorting something, except that the power steering was clearly effected too, so it seems like the belt was actually slipping. Anyhow I'm glad it had an easy fix.

Anyone else have another idea, or seen this happen?
1995 850 Turbo, Sedan
1996 850 N/A, Sedan

User avatar
RickHaleParker
Posts: 7200
Joined: 25 May 2015, 14:30
Year and Model: See Signature below.
Location: Kansas
Has thanked: 8 times
Been thanked: 978 times

Post by RickHaleParker »

Weak Tensioner. Oil on belt. Worn belt.
Active
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2017 Ford PIU. 3.5l, Twin Turbo, 365 Hp.
............................
Past
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000. ( Killed by a plastic radiator. )
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion ( I moved, the project did not )
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0. ( Transmission dead after sitting for a winter )

Sommerfeldt
Posts: 1148
Joined: 29 Jul 2008, 13:25
Year and Model: 2018 S90 T8
Location: Oslo Area, Norway
Has thanked: 55 times
Been thanked: 42 times

Post by Sommerfeldt »

Any fluid on the belt will be a lubricant while it's there. :) Water isn't a great lubricant though, so Rick has a point - the tensioner could be weak, and the belt could be due for a replacement.
If there was oil on it, the problem would probably be more prevalent, and usually it'd be visible as well.

- S
2018 S90 T8 Inscription - glossy black with amber interior and dark as night rear windows.
[Gone] '96 855 T5 - R bumper and spoiler, Koni Yellows & blue H&R springs all 'round.
[Sold] '97 S70 T5
[Gone] '95 855 T5-R - one of the black ones... sadly stolen and wrecked.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post