



Next up, and inspired by the work of one chap on a different forum, I bought a small pack of Whitemorph and used it to repair some broken trim mounts on my column shroud. I was very surprised by how economical this product was, I must have only used about 10g to make both these. It also has quite a long work-time, which is excellent for fine-tuning or awkward areas. One of the mounts is threaded two, I assembled the shroud off the car, put the fastener in place and then moulded it around the fastener and remnants of the old mount. Its easy to drill, easy to sand, and very east to get a nice smooth finish with if it were to be used in a visible area. Very impressed!










