So I did a head job & replaced turbo along with all coil wiring. Went to start it up after re-assembly and it sounds exactly like a 1960 VW bug
Any ideas or diagnosis procedures?
Thanks
Nathan
I have not tried "feeling for it" too extensively, but will tmrw morning. Yes... All new gaskets & head bolts torqued to spec.BlackBart wrote: 03 Nov 2020, 12:48 When it's cold....can you start it up and hold your hand in various places to see where any air is jetting out around the manifold? Did you use new gaskets and hardware? All torqued to spec?
Hmmmm..... Yes. Individual gaskets.... We'll see tmrw morningabscate wrote: 03 Nov 2020, 17:55 You can also put a bit of marvel mystery oil into the manifold and look for smoke pouring out
If you used the individual manifold gaskets, my guess is one slipped off
Because it was running rough before and it would not start after sitting for a extended period. I'm think leaking fuel injector(s).Nathan79 wrote: 05 Nov 2020, 07:41 soon as I disconnected the downpipe some fuel came out. "Can't be good right"?