Vida CEM swapping

efe09 · Post by **efe09** » 13 Jan 2021, 12:32

hi RickHaleParker ,

thanks for the useful tips

Post by **vtl** » 13 Jan 2021, 19:58

The Arduino code has a CAN-bus reset routine, which brings all devices back to live. You may want to add progModeOff(); as a last line in setup() function and remove everything from the loop() function.

efe09 · Post by **efe09** » 15 Jan 2021, 10:01

>>> more is not possible >>>

why does the program not continue

Post by **vtl** » 15 Jan 2021, 10:22

You have no jumpers on J1, the end of bus is not terminated, lots of signal reflections.

https://www.allaboutcircuits.com/indust ... made-easy/

efe09 · Post by **efe09** » 15 Jan 2021, 11:12

Should I set a jumper on both CAN bus shields
put a jumper on J1?
Can you please help me out,
I do not have so much experience with it,
but I would like to complete this project successfully.

Post by **vtl** » 15 Jan 2021, 11:58

On both shields.

efe09 · Post by **efe09** » 15 Jan 2021, 12:21

Thanks vtl for your helpful tips,
I will try again tomorrow with Jumper on J1, of course if it does not snow tomorrow or is too cold outside.

paddy0174 · Post by **paddy0174** » 16 Jan 2021, 12:11

I can't be of any help "testing-wise", I still need to do some other things before I can even think about ordering the parts.

But if there are language barriers between english and german, I'm happy to help!

@efe09
Wenn Du Probleme bei der Übersetzung hast, kannst Du mir gerne Bescheid geben.

Gruss aus München
(translation: If you have problems with translations, just drop me a note! Greetings from Munich)

fkruis · Post by **fkruis** » 24 Jan 2021, 18:31

hi,

i was wondering if this board is a good candidate to use the code provided
https://copperhilltech.com/teensy-4-1-t ... 0-ips-lcd/

Post by **vtl** » 25 Jan 2021, 06:11

It is good, but very expensive for the task.

Vida CEM swapping

Re: Vida CEM swapping