So I've got a really weird problem with one of my headlights. When I flip the switch to turn the headlights on, they both act normally for about 5 seconds. Then the left one (when looking at the car from the front) points down, and I get a message in the car saying that there is a headlight failure. The headlights work fine when have have them on the automatic setting and the headlights are able to go into high beams. But I cannot put them on the permanent high beams because when I flip the switch to the headlight on setting, the left one fails.
I scanned it with ViDA and it gave me CEM-8F15. This headlight was replaced, so I'm not sure if it has something to do with that.
2007 S60R headlight problems
-
RickHaleParker
- Posts: 7129
- Joined: 25 May 2015
- Year and Model: See Signature below.
- Location: Kansas
- Has thanked: 8 times
- Been thanked: 958 times
Pull up the information for CEM-8F15. The answer is right there at your finger tips.
VIDA wrote:Possible source
- The actuator motor in the xenon lamp housing has jammed
Damaged actuator motor in the xenon lamp housing.
⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙⸙
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000.
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0.
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000.
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 3 Replies
- 2616 Views
-
Last post by - Pete -
-
- 3 Replies
- 695 Views
-
Last post by Iceman12596