2015 S60 MAP sensor location

tflesui · Post by **tflesui** » 10 Feb 2022, 22:04

Greetings!

Need some assistance as I've not been able to find any straightforward answer anywhere else.. My CEL came on the other day and codes P0108 & P0106 were present. After clearing the codes P0106 has remained and my first thought is to try and clean the MAP sensor.

I cannot, for the life of me, determine whether my 2015.5 T6 4cyl Platinum has a MAP sensor and/or where it might be located. Has anyone found a MAP sensor on this year/trim and had success trying to clean it? Any help would be greatly appreciated, thank you

Post by **regent** » 11 Feb 2022, 08:04

Location of MAP sensor on intake manifold.
Pos. # 5

Source: https://parts.volvocarslisle.com/showAs ... ly=7468356

: Capture.PNG (175.45 KiB) Viewed 4295 times

I would also inspect the electrical connector and then have a look at the PCV Breather (oil trap box) just for good measure.
Hope this helps

tflesui · Post by **tflesui** » 14 Feb 2022, 09:12

@regent,

This is a huge help! Thank you! I've been driving around with the CEL on for about a week and a half and I commute ~80 miles to work (each way) so getting this taken care of will account for much peace of mind. Thank you again and I'll report back when I get this looked at.

tflesui · Post by **tflesui** » 25 Apr 2022, 16:49

Been a while but I wanted to give an update now that this issue has been resolved. Thanks to @regent for help with the diagram. I was able to locate the MAP sensor and attempted to clean it but I was not able to clear the CEL. I ended up purchasing a new
MAP sensor from FCP Euro and swapped them out fairly quickly. After doing so, CEL is gone! I've added some pictures for anyone else who may need assistance.

: 1.jpg (2.06 MiB) Viewed 3545 times

: 2.jpg (2.8 MiB) Viewed 3545 times

: 3.jpg (1.48 MiB) Viewed 3545 times