Vida CEM swapping

[Dudde]

Here is an attempt on decrypting the eeprom.

out.rar

45 61 80
26 08 16 54 70 79

I can already decrypt the eeprom. I need a synchronisation.

I need ABS id

[oscilloscope]

Here is an attempt on decrypting the eeprom.

out.rar

45 61 80
26 08 16 54 70 79

I can already decrypt the eeprom. I need a synchronisation.

I need ABS id

As far as i know Abs id is not required for cem L or H

[yagger]

What way do you mean? There is commercial way for example... )

Yes I have herd of them , from what I remember there very exspensive. , although at this current time It wouldn't load on my phone. So I couldn't confirm if its the same price.

If you tell by phone about "this" case and forum topic, price for this option is $150 for you. If you have a DiCE it is possible to do everything via Internet. If you do not have a DiCE also need to pay for shipping.

[oscilloscope]

What way do you mean? There is commercial way for example... )

Yes I have herd of them , from what I remember there very exspensive. , although at this current time It wouldn't load on my phone. So I couldn't confirm if its the same price.

If you tell by phone about "this" case and forum topic, price for this option is $150 for you. If you have a DiCE it is possible to do everything via Internet. If you do not have a DiCE also need to pay for shipping.

At the time I couldn't see the fee on there site as it wouldnt load correctly. , and that price out ways the cost of the job., by way off. I have considered purchasing DiCE

[RickHaleParker]

If you have a DiCE it is possible to do everything via Internet. If you do not have a DiCE also need to pay for shipping.

If VIDA is not installed on the remote machine, is DiCE the only J2534 interface you can work with over the internet?

[DJGlock]

Sorry was 50 downloads only, here are both again...

Also Windows 10 doesn't notice me about anything, maybe it is location based on 3 computers i get nothing. Maybe defender in US sees something problematic in this code...

Dear T5Luke
I tried to use UDSTool Crack to get PIN for my XC70, but got the following issue.
Car: XC70 2007, YV1SZ595771286825
Dice: Chinese clone, but works good (as per my experience).
Repro steps:
The car stayed for a day, I just opened it, connected DICE and run your tool. Did not touch ignition lock at all (so it was in position 0).
It tried to start the process, but failed (log below).

Repeated several times - no luck. Had a small conversation with vtl, he advised to ask for help here.
Does the response from CEM tells you anything useful? Vtl told me that it looks like one of modules did not enter sleeping mode and hence the response was bad. Any ideas how to fix it? May be you have any other build with extended logging?

[yagger]

If you have a DiCE it is possible to do everything via Internet. If you do not have a DiCE also need to pay for shipping.

If VIDA is not installed on the remote machine, is DiCE the only J2534 interface you can work with over the internet?

VIDA not need. DiCE is required.

[NuovoRecord]

Are there any tricks to soldering to these ECU pins? I just had a hell of a day trying to get wires connected. The pads seem to lift at the slightest movement.

[vtl]

Are there any tricks to soldering to these ECU pins? I just had a hell of a day trying to get wires connected. The pads seem to lift at the slightest movement.

30AWG copper wire w/ silicone insulation, regulated soldering iron/station.

[NuovoRecord]

I managed to brick my CEM. Be careful.