crankshaft position sensor-
-
stevenammo27
- Posts: 3
- Joined: 06 May 2023, 21:40
- Year and Model: 2009 c 70 t5 convert
- Location: Austin,Texas
2009 Volvo C T5 convertible. overheated because the stupid gage isn't working apparently I pulled over after it died. cooled down for over an hour,, when I went to start it so I could put more water in it, it would not start. I checked all the relays and cheeses under the hood that I knew of. are there fuses on the inside box that I should check ? I even tried to reset the computer by pulling the two multipin connectors that are up front by the air filter . no luck on starting it. Please advise me of anything you can do to help thanks
-
stevenammo27
- Posts: 3
- Joined: 06 May 2023, 21:40
- Year and Model: 2009 c 70 t5 convert
- Location: Austin,Texas
Where is it located on my 2009 c70 ? how do i test it before replacing it ? will it keep car from starting after it overheats ?
- erikv11
- Posts: 11913
- Joined: 25 Jul 2009, 14:03
- Year and Model: 850, V70, S60R, XC70
- Location: Iowa
- Has thanked: 312 times
- Been thanked: 818 times
I don't have an answer; your 2009 C70 is a very different car from the older ones discussed here, you may have better luck getting a response by posting the question over here: viewforum.php?f=25
'95 854 T-5R, Motronic 4.4, 185k
'98 V70, T5 tune-injectors-turbo, LPT engine, 304k, daily driver
'06 S60 R, 201k
'07 XC70, black, 205k
'07 XC70, willow green, 223k
gone: '96 NA 850 210k, '98 NA V70 182k, '98 S70 NA 225k, '96 855 NA 169k
'98 V70, T5 tune-injectors-turbo, LPT engine, 304k, daily driver
'06 S60 R, 201k
'07 XC70, black, 205k
'07 XC70, willow green, 223k
gone: '96 NA 850 210k, '98 NA V70 182k, '98 S70 NA 225k, '96 855 NA 169k
- Krons
- Posts: 1113
- Joined: 09 Jan 2022, 05:58
- Year and Model: 08S60 05XC90 02S60
- Location: Des Moines, IA
- Has thanked: 198 times
- Been thanked: 215 times
Worth a new thread in the link Erik posted for newer C70s.stevenammo27 wrote: 07 May 2023, 13:06 2009 Volvo C T5 convertible. overheated because the stupid gage isn't working apparently I pulled over after it died. cooled down for over an hour,, when I went to start it so I could put more water in it, it would not start. I checked all the relays and cheeses under the hood that I knew of. are there fuses on the inside box that I should check ? I even tried to reset the computer by pulling the two multipin connectors that are up front by the air filter . no luck on starting it. Please advise me of anything you can do to help thanks
Help provide more info on “would not start”. Can you hear the starter spin? Does engine spin over? Does engine fire at all?
The P1s are known to overheat when low on coolant and can overheat quickly. How much did you add, I.e. how low was it? The ‘octopus’ hose under the airbox is a known failure point causing leaks.
08 S602.5T/05 XC902.5T/02 S602.4T
08 C702.5T (sold)
05 S402.4i (RIP, timing belt failure)
The non-Swedes:
25 Mazda MX-5 / 17 Frontier Pro-4X / 17 Ford Focus
17 R1200GS / 15 Versys 1000 / 11 DR-Z400S
08 C702.5T (sold)
05 S402.4i (RIP, timing belt failure)
The non-Swedes:
25 Mazda MX-5 / 17 Frontier Pro-4X / 17 Ford Focus
17 R1200GS / 15 Versys 1000 / 11 DR-Z400S
-
- Similar Topics
- Replies
- Views
- Last post
-
- 6 Replies
- 5084 Views
-
Last post by regent
-
- 2 Replies
- 1302 Views
-
Last post by ducttapeandzipties
-
- 13 Replies
- 11605 Views
-
Last post by abscate
-
- 7 Replies
- 3574 Views
-
Last post by chrism
-
- 1 Replies
- 1370 Views
-
Last post by jimmy57






