Is there any information in some manual how much movement the M90 clutch slave cylinder should have?
Even with the pedal fully depressed and in first or reverse gear there is some slight creep in my homebuilt car and I suspect maybe my slave doesnt get enough throw. (everything between the engine and gearbox is new or in good shape with less than 1500 miles on it)
I would be very grateful if anyone has that information available or can check it on a working car.
M90 clutch slave cylinder throw?
-
RickHaleParker
- Posts: 7199
- Joined: 25 May 2015, 14:30
- Year and Model: See Signature below.
- Location: Kansas
- Has thanked: 8 times
- Been thanked: 978 times
Don't know if it is written some place but stroke is about 18mm - 19mm
falcor75 wrote: 26 Apr 2024, 10:09 Is there any information in some manual how much movement the M90 clutch slave cylinder should have?
Active
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2017 Ford PIU. 3.5l, Twin Turbo, 365 Hp.
............................
Past
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000. ( Killed by a plastic radiator. )
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion ( I moved, the project did not )
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0. ( Transmission dead after sitting for a winter )
1998 C70, B5234T3, 16T, AW50-42, Bosch Motronic 4.4, Special Edition package.
2017 Ford PIU. 3.5l, Twin Turbo, 365 Hp.
............................
Past
2003 S40, B4204T3, 14T twin scroll AW55-50/51SN, Siemens EMS 2000. ( Killed by a plastic radiator. )
2004 S60R, B8444S TF80 AWD. Yamaha V8 conversion ( I moved, the project did not )
2005 XC90 T6 Executive, B6294T, 4T65 AWD, Bosch Motronic 7.0. ( Transmission dead after sitting for a winter )
-
- Similar Topics
- Replies
- Views
- Last post