Glue for exterior body plastics 06 S60

Post by **erikv11** » 03 May 2024, 22:20

I need to glue a clip back onto a small exterior trim piece, a straight piece under the driver's side rear door.

: Trim piece; IMG_4489.jpeg (721.09 KiB) Viewed 370 times

Looks like someone has already been in there, but their glue repair finally failed.

: Clip with glue splooge; IMG_4490.jpeg (467.49 KiB) Viewed 370 times

: Clip has detached; IMG_4491.jpeg (425.46 KiB) Viewed 370 times

The back of the plastic is stamped "PP+EPDM+M10" I suspect it is just polypropylene?

: Plastic stamping; IMG_4492.jpeg (588.39 KiB) Viewed 370 times

Any suggestions for an adhesive that will stick?

Post by **scot850** » 03 May 2024, 23:16

JB weld Plastic (black). Roughen the surfaces and mix the JB weld and stick it. Give it 24hrs to set. It does dry in about an hour but but on the surface. Give it 24hrs for good measure. I use that to rebuild broken P80 dashboard mounts.

Neil.

enotslim · Post by **enotslim** » 04 May 2024, 06:07

I intend to try plastic welding for such repairs. Given the variety of materials now available it seems there will be something compatible with most common "legacy" plastic. With practice welding seems more likely to be successful and stable long term. Joins that are hidden from view, as in this case, can dispense with some aesthetics.

Post by **volvolugnut** » 04 May 2024, 07:39

PP should indeed be Polypropylene. With addition of EPDM and M10.
See this link for EPDM adhesive:
https://www.permabond.com/resource-cent ... -adhesive/
volvolugnut

Post by **vtl** » 04 May 2024, 08:36

Plastic welder on Amazon. Get another donor piece to melt, with the same plastic kind letters.

The reason why plastic repairs fail is different thermal contraction rate of different plastics. If the same plastic was used for repair, the repair will hold forever.

Post by **MoVolvos** » 04 May 2024, 11:26

.
Lots of good ideas in these.
.

.