2007 s80 3.2 misfire
-
Barnmachinist
- Posts: 2
- Joined: 28 August 2024
- Year and Model: 2007 s80
- Location: Finland
2007 s80 3.2 misfire
Oks i dont know where to start. I got this car few months ago, i bought it broken. Dont remember correct dtc codes but the were misfire cylinder 4,5 and 6. And 1 more missfire code what i think meant misfire on every cylinder. Now i have worked on engine and almost everything is changed. First i out all new plugs and coils, no change. Fuel pressure sensor, nothing. I changed whole engine wit sensors etc to 100k kms driven ad still misfiring. Got injectors repaired and tested. Nothing. Only old things thats left is wiring harness, ecu and air mass meter. No vacuum leaks. 4,5 and 6 bank has melted cat but i got rid of all cats and i out them back when the engine is running good. Usually misfire is bad and i cant push gopedal not even tiny bit but when car is operating temp it runs ok but not good. Usually it works best at over 50% throttle and baddest is under that. Low rpms and mild accelarating is when it stutters and hesitates most. What the f**k i do next
cheers. Car orginally has 290kms on odometer.
- MoVolvos
- Posts: 5273
- Joined: 15 January 2012
- Year and Model: S&V70XC,S60,C30,XC90
- Location: NC
- Has thanked: 310 times
- Been thanked: 524 times
.Barnmachinist wrote: ↑28 Aug 2024, 14:28 Oks i dont know where to start. I got this car few months ago, i bought it broken. Dont remember correct dtc codes but the were misfire cylinder 4,5 and 6. And 1 more missfire code what i think meant misfire on every cylinder. Now i have worked on engine and almost everything is changed. First i out all new plugs and coils, no change. Fuel pressure sensor, nothing. I changed whole engine wit sensors etc to 100k kms driven ad still misfiring. Got injectors repaired and tested. Nothing. Only old things thats left is wiring harness, ecu and air mass meter. No vacuum leaks. 4,5 and 6 bank has melted cat but i got rid of all cats and i out them back when the engine is running good. Usually misfire is bad and i cant push gopedal not even tiny bit but when car is operating temp it runs ok but not good. Usually it works best at over 50% throttle and baddest is under that. Low rpms and mild accelarating is when it stutters and hesitates most. What the f**k i do nextcheers. Car orginally has 290kms on odometer.
Have you consider perhaps a worn or dirty ETM. Generic photos found online, clean vs dirty and sticky butterfly. Don't over spray or saturate the inside. Spray on a lint free clothe and rub without bending the butterfly pivot, shaft and plate. Clean behind everything as much as possible.
. .
Blessings,
BKM
2008 C30 T5 2.0 M66
2007 S60 2.5T - New Project
2003 S80 T6 Transmission DIED
2000 S70 SE Base - New Project
1998 S70 T5 Prior
1989 240 Wagon Prior
BKM
2008 C30 T5 2.0 M66
2007 S60 2.5T - New Project
2003 S80 T6 Transmission DIED
2000 S70 SE Base - New Project
1998 S70 T5 Prior
1989 240 Wagon Prior
-
Barnmachinist
- Posts: 2
- Joined: 28 August 2024
- Year and Model: 2007 s80
- Location: Finland
Thats on my mind too because i used to play alot with those on older volvos with magneti marelli flaps but as i remember when i changed engine etm looked fine to my eyes, no dirt etc. Peehaps i have to look it
-
- Similar Topics
- Replies
- Views
- Last post
-
- 19 Replies
- 9290 Views
-
Last post by Barledge
-
- 1 Replies
- 1585 Views
-
Last post by humbertoflores63






