P80 Volvo 3D Parts Library Build

Post by **Goupil** » 17 Apr 2025, 13:59

I bought some 85A TPE, first time printing flexible filament, first attempt went really nice. Will make a few more and report back once installed on the car.

scot850 wrote: 13 Apr 2025, 17:34 I saw similar connectors on AliExpress with a connector that looks like the one that ones to the relay on the top of the radiator. I meant to buy a couple just to see if they are the same or would work for P80's.

Neil.

I initially ordered some connectors from ali, the "standard" big 2 pin P80 ones can be found (only in pigtails).
Seller ended up cancelling the order due to supply issues, and this 3d printed option appeared in the meantime, so I figured i'd give it a try.

Post by **BlackBart** » 18 Apr 2025, 15:13

How are people modeling NLA parts that are warped / bent / cracked / shrunk over time?

Post by **ZionXIX** » 23 Apr 2025, 20:18

BlackBart wrote: 18 Apr 2025, 15:13 How are people modeling NLA parts that are warped / bent / cracked / shrunk over time?

I suppose your only options would be pulling a better condition one from the junkyard, ebay or just trial and error in the modeling process.

crasbe · Post by **crasbe** » 25 Apr 2025, 04:56

BlackBart wrote: 13 Apr 2025, 10:13 Would the resulting part be a soft pliable boot, or rigid plastic?

You can find more information about the seal in this thread here:
viewtopic.php?t=101867&start=10

The green one in the picture is made from PLA, which is hard, but the real ones were printed from TPU and TPE, which is soft.

Post by **scot850** » 25 Apr 2025, 08:28

I just received my P80/P2 transmission axle oil seal set from V-Prints. Thy look really good. I now have to wait for an opportunity to use them. This though makes me realize that the one I really need is a seal installing tool for the AWD RH axle and sleeve seal.

Neil.