Strut mount bearing curvature Topic is solved

aeg · Post by **aeg** » 11 Jul 2026, 20:37

I just got this strut mount bearing. The screws are off-vertical with it sitting on the desk. The plate is concave. Is this how it should be, or was it damaged in shipping?

: IMG_1074c.jpg (24.91 KiB) Viewed 460 times

: IMG_1075c.jpg (26.35 KiB) Viewed 460 times

: IMG_1076c.jpg (28.57 KiB) Viewed 460 times

: IMG_1077c.jpg (35.34 KiB) Viewed 460 times

Post by **scot850** » 11 Jul 2026, 23:00

Here is a link to IPDUSA website. Compare with the images in this to your sample:

https://www.ipdusa.com/products/5458/Up ... crumbs=987

Neil.

aeg · Post by **aeg** » 12 Jul 2026, 16:15

scot850 wrote: 11 Jul 2026, 23:00 Here is a link to IPDUSA website. Compare with the images in this to your sample:

Every image on the Internet, including those on the IPDUSA website, is taken at an oblique angle and does not contain a straightedge for reference. I don't know how any of those could be useful for comparison.

Post by **abscate** » 13 Jul 2026, 01:43

I’m pretty sure the strut bearing surface isn’t flat. That could not get bent like that from flat in shipping, without destruction of the box

Post by **Krons** » 13 Jul 2026, 04:22

I’d send it back.

Edit: Scratch that, I stand corrected. Never underestimate the knowledge of the MVS community!! I would never think that was normal, good to see they are all that way.

Post by **jreed** » 13 Jul 2026, 05:25

I did see one image that shows the curvature, see below:

: Upper Strut Mount Bearing - Sachs 802107 - Volvo 31200599 curved.jpg (22.64 KiB) Viewed 399 times

Post by **Chuck W** » 13 Jul 2026, 05:25

They're meant to be like that. It matches the curvature of the strut tower.

Post by **scot850** » 13 Jul 2026, 08:35

I took some pictures and will upload them later when I have more time.

They are definitely bent on at least 2 sides. The ones I have are crusty with surface rust but came off a car and are OE units.

Neil.

Post by **scot850** » 13 Jul 2026, 15:39

Pictures as promised:

: Strut bearing picture (1)

: Strut bearing picture (2)

: Strut bearing picture (3)

Hopefully that helps

Neil.

rrres · Post by **rrres** » 13 Jul 2026, 16:07

You can also draw a straight line and see the curvature.

: Sachs-802107-Volvo-31200599.jpg (17.54 KiB) Viewed 367 times