'94 850 N/A died at stop and while running.

warrenout · Post by **warrenout** » 30 May 2009, 09:59

1994 850 n/a developed a problem. Backed out of drive-way and car died. Ran fine for the 40 mile commute. Started fine in parking lot, ran a few minutes and died and had problems re-starting. Once restarted, ran fine for the 40 miles home. This car runs like a champ normally. Not a miss nor a hiccup. What could be the problem? I removed the MAF sensor, cleaned with CRC and also cleaned the wire connector pins with CRC. Restarted an ran fine. Could this have been my problem?

Post by **Ozark Lee** » 01 Jun 2009, 19:33

Do you have any codes from port A-2? If so, post them back.

...Lee

warrenout · Post by **warrenout** » 19 Jun 2009, 10:49

I pulled codes:
131 - no rpm signal
241 - low egr flow
314 - no cam signal
Replaced cam sensor, fuel filter, spark plugs, dist. cap and rotor. Runs like a champ. Fuel economy has increased to 30+ mpg.

Post by **MadeInJapan** » 19 Jun 2009, 12:25

Thanks for posting back as to your solution.
I would have suspected cam sensor from your description.
It was good you did a tune-up at the same time!