Clutch replacement

[NitroVolvo]

Thanks,

I'm looking into the Alldata subscription now!

[abscate]

I’ll add this on this job.

It’s about 10 hours including all those other things that you do in there. I broke it up over two weekends and two days each weekend for 2-3 hours.

First prep, struts off prep car for engine drop

Second. Subframe drop engine drop, engine trans separation.

Third rework clutch , reconnect engine / transmission

Fourth Finalise and clean up

[abscate]

I am going to add to this.

When I did my P2, I found a hybrid of the Dual mass Flywheel and non-self adjusting clutch. This was stock build from the Ghent factory.

So, I would hold off ordering parts until you get the thing apart and see what parts you have

[NitroVolvo]

Does the Alldata service provide info on what else I can be doing while I have everything out?

[abscate]

It has procedures for most everything but you have to come up with the list yourself

Clutch
Pressure plate
Flywheel resurfacing..
Rear enginecoil seal
Transmission oil seal
Release bearing