cv joint bellows replacement

IgorA · Post by **IgorA** » 28 Jun 2013, 03:48

Dear gentlemen,
I would like to replace CV Joint Bellows on my Volvo s40 1997 (AW 50-42 automatic transmission).
I will also replace Shock Absorbers and Ball Joints.
Your opinion , please, the best way to remove CV Joint for this.
Thank you !!!

Post by **xHeart** » 28 Jun 2013, 07:46

I found this DIY post very helpful in deciding my next steps, please see it as reference https://www.matthewsvolvosite.com/forums/viewtopic.php?f=1&t=29716&start=14

IgorA · Post by **IgorA** » 09 Jul 2013, 13:49

Tightening Torque for CV Joint Nut, does somebody know?

Post by **xHeart** » 09 Jul 2013, 20:20

IgorA wrote:Tightening Torque for CV Joint Nut, does somebody know?

Would you take a picture and post here?

IgorA · Post by **IgorA** » 10 Jul 2013, 15:42

OK, will do. Thank you for your interest .

IgorA · Post by **IgorA** » 12 Jul 2013, 16:43

This nut I mean

Post by **JDS60R** » 12 Jul 2013, 16:49

here you go

IgorA · Post by **IgorA** » 13 Jul 2013, 08:53

Thank you very much !

IgorA · Post by **IgorA** » 01 Aug 2013, 13:49

That's interesting , just because I do not have any problems with CV joints (no strange sounds, no excessive consumption) , it is interesting
do CV joints wear at all? At least to some allowable limit?