IPD sale Volvo Parts
Did you know? 🤔
Logged in users can get email notification of topic replies Log in or register (free).
Amazon Link Buy your stuff using this and it helps MVS!

2008 xc90 V8 - slow start

Help, Advice, Owners' Discussion and DIY Tutorials on Volvo XC90s. The XC90 proved to be very popular, and very good for Volvo's sales numbers, since its introduction in model year 2003 (North America).
kiwiV8
Posts: 4
Joined: Sun Feb 03, 2019 9:57 pm
Year and Model: 2011 XC90
Location: Auckland
Has thanked: 0
Been thanked: 0
New Zealand
kiwiV8

Re: 2008 xc90 V8 - slow start

Post by kiwiV8 » Sun Feb 24, 2019 2:55 pm

just posting an update, at the end I went with original design and got oilite bushes installed back in by an engineering shop as I couldn't wait. You should be able to order some from here

https://www.bowman.co.uk/bearings/oilit ... n-bearings

you'd need one flanged and one plain



sergiy
Posts: 1
Joined: Sat May 17, 2014 12:50 am
Year and Model: 2003 V40
Location: San Jose
Has thanked: 0
Been thanked: 0
sergiy

Re: 2008 xc90 V8 - slow start

Post by sergiy » Tue Mar 05, 2019 12:09 pm

Hi kiwiV8.

Can you share parts numbers you used? Or sizes of the bearings? You mentioned that one is with the flange - is flange size included in 10mm length?

I would appreciate your info.

Thanks,

Sergiy



kiwiV8
Posts: 4
Joined: Sun Feb 03, 2019 9:57 pm
Year and Model: 2011 XC90
Location: Auckland
Has thanked: 0
Been thanked: 0
New Zealand
kiwiV8

Re: 2008 xc90 V8 - slow start

Post by kiwiV8 » Sun Mar 10, 2019 7:43 pm

sure I think I still have the old loose bushing laying around I'll try and take some measurements.



kiwiV8
Posts: 4
Joined: Sun Feb 03, 2019 9:57 pm
Year and Model: 2011 XC90
Location: Auckland
Has thanked: 0
Been thanked: 0
New Zealand
kiwiV8

Re: 2008 xc90 V8 - slow start

Post by kiwiV8 » Sun May 05, 2019 5:12 pm

The dimensions on mine are bad. So i'm not sure what is a new good one should be like but this is a starting point i guess.

There're 2 in total, a flanged one located in the cap, and a cylindrical one

Flanged dimensions -- this one was in slightly better condition
OD 11.49mm
ID 8.28mm << this is WORN
Height to Flanged bits 7.53mm
Total Height including flange 9.05mm


Cylindrical
OD 11mm
ID 8.57mm << WORN AF also tapped to pull this one out
Height 11.39mm



Post Reply