2007 XC90 - "Claw" replacement in shifter

thecamthom · Post by **thecamthom** » 16 Jul 2015, 08:07

Hi folks,

Just bought a 2007 XC90. The previous owner informed me that a part in the shifter needs to be replaced. He referred to it as a "claw" and gave me the replacement part.

The reason it needs to be replaced - when the shifter is in DRIVE it sits loosely and will slide over into MANUAL position. Hasn't caused any issues to my knowledge, but because I have the part I would like to replace it.

How would I go about getting into the inner workings below the shifter? Is this a difficult job? I am no mechanic but can follow directions and diagrams. Any help or instruction is greatly appreciated.

Thanks in advance,

- Cameron

Ou2mame · Post by **Ou2mame** » 16 Jul 2015, 22:18

I believe the plate just lifts up front the rear. My clips are broke so I used some shoe goo to glue it down.