1999 V70 ETM removal

jon1 · Post by **jon1** » 03 Sep 2015, 19:27

I am trying to take out the ETM module to have it rebuilt by BBM Reman. I was able to disconnect the connector after a while, but the problem I have now is that the wire cable is snaked through, around and under a part of the engine. The connector end is too big to fit through anywhere, so I can't pull it out. Does anyone have experience with this problem?

Post by **Matty Moo** » 03 Sep 2015, 20:24

It's a bracket that holds the starter. Remove it.

Post by **gmh** » 03 Sep 2015, 21:13

Matty Moo wrote:It's a bracket that holds the starter. Remove it.

+1
Here's an old thread with a bit of detail about removing the bracket.

https://www.matthewsvolvosite.com/forums ... 289#p82289

jon1 · Post by **jon1** » 04 Sep 2015, 10:03

Thank you, I'll try that. kind of difficult for a novice.

jon1 · Post by **jon1** » 04 Sep 2015, 12:29

Bracket removed and ETM is out. Thank you, Jon

Post by **precopster** » 05 Sep 2015, 17:13

The turbo P80s have poor access to that whole area. Lots of skinned knuckles.