i am a very new member on this site. In the last 8 Month i read a lot on this page and collected a huge knowledge and information base. I have a Volvo xc90 2.9 T6.
I had problems with ANTI-SKID Service urgent-----I could solve it (thanks to MVS)
I found a lot of water in my car , so i found how to clean the Sun-roof tubes
i had problems with SRS and AIrbag error -------- I could solve it too !!!
I had problems with my transmission---- After a fluid flush and LUCAS antli slip----- much better now
NOw i have changed my timing belt and i have done a misstake, i moved the camshufts in the left direction .....
After assembling i have a Fault code ECM-643A Camshaft position, inlet Signal too high
I moved the timing belt one cog forward and two cogs forward and back. Than i moved the belt one cog back....... The error is the same.
I bought now Camshaft Alignment tool, and do not exactly understand what i should do now?
May be there is somebody who can give me an advice?
I would be very thankfull and share my expirience.