Is the drive geometry standardized between manufacturers for the max access pass through ratchet tools? In other words, are the sockets interchangeable between Craftsman, Crescent, Kobalt... etc?
bob-in-va
Pass Through Ratchets
-
- Similar Topics
- Replies
- Views
- Last post
-
- 5 Replies
- 1588 Views
-
Last post by rspi
-
- 42 Replies
- 10417 Views
-
Last post by erikv11
-
- 10 Replies
- 2817 Views
-
Last post by mdewalle
-
- 0 Replies
- 347 Views
-
Last post by phils94850
-
- 4 Replies
- 1622 Views
-
Last post by phils94850