IPD sale Volvo Parts
Did you know? 🤔
Logged in users can get email notification of topic replies Log in or register (free).
Amazon Link Buy your stuff using this and it helps MVS!

Broken power connector for 1996 Volvo 850 ABS Control Module

Help, Advice and DIY Tutorials on Volvo's extremely popular car line -- Volvo's 1990s "bread and butter" cars -- powered by the ubiquitous and durable Volvo inline 5-cylinder engine.

1992 - 1997 850, 850 R, 850 T5-R, 850 T5, 850 GLT
1997 - 2000 S70, S70 AWD
1997 - 2000 V70, V70 AWD
1997 - 2000 V70-XC
1997 - 2004 C70

kcanmoore
Posts: 1
Joined: Thu May 16, 2019 10:44 am
Year and Model: 1996 850
Location: Kennesaw, GA
Has thanked: 0
Been thanked: 0
United States of America
kcanmoore

Broken power connector for 1996 Volvo 850 ABS Control Module

Post by kcanmoore » Thu May 16, 2019 10:58 am

The code reader said the ABS Control Module was faulty and I ordered a new one online. After locating and buying an E5 external torx socket, I followed the instructions on this site and removed the old module. I didn't notice until I was about to reconnect the power connector, but the plastic plug slipped off of the round metal clips that fit on the two posts (the plug is not in very good shape) and I cannot determine which wire goes on which post in order to prevent a short-circuit to the new module, or worse, to the onboard computer. The posts are identical and not color-coded. Any suggestions?



Ozark Lee
MVS Moderator
Posts: 14772
Joined: Thu Sep 07, 2006 8:24 am
Year and Model: Many Volvos
Location: USA Midwest
Has thanked: 4 times
Been thanked: 40 times
United States of America
Ozark Lee

Re: Broken power connector for 1996 Volvo 850 ABS Control Module

Post by Ozark Lee » Thu May 16, 2019 9:38 pm

If you get them backwards it won't short anything out, the pump motor will just run backwards. It is a 50/50 crapshoot but I can't think of any damage that would be caused by being on the losing side of the bet.

...Lee


'94 850 N/A 5 speed
'96 Platinum Edition Turbo
Previous:
1999 V70XC - Nautic Blue - Totaled while parked.
1999 V70XC - RIP - Wrecked Parts Car.
1998 S70 T5
1996 850 N/A
1989 740 GLT
1986 740 GLT
1972 142 Grand Luxe

User avatar
manovlov
Posts: 189
Joined: Wed Jul 06, 2011 6:47 am
Year and Model: 850 WAGON 95 2.5-20V
Location: GRENOBLE
Has thanked: 38 times
Been thanked: 8 times
France
manovlov

Re: Broken power connector for 1996 Volvo 850 ABS Control Module

Post by manovlov » Thu May 16, 2019 9:48 pm

Are the wiring the same long size ? Is it possible to see on a wiring diagram which goes or come from where to where ?

When plugged, switch ignition on and read codes again ? Maybe the issues will be seen..

Manov (newbie)


Vroum !

GrumpyOldMan
Posts: 34
Joined: Sat Dec 13, 2008 8:01 pm
Year and Model:
Location: Awestralia
Has thanked: 0
Been thanked: 0
GrumpyOldMan

Re: Broken power connector for 1996 Volvo 850 ABS Control Module

Post by GrumpyOldMan » Sat May 18, 2019 1:37 am

Hope this helps.

I had to rebuild my abs module.
Been dreading that as the pump wires insulation was perished to begin with.
1.jpg
Removed the abs module and what was left of the insulation disintegrated.
2.jpg
Pulled the pump cap off so I could re-sleeve the wires best I could.
Cleaned the wires (one at a time).
Pushed white heat shrink as far into the body as I could.
Sleeved the rest of the wire with the correct colour shrink.
Pushed a bit of silicon into the the cable entry on the pump body to try and stop the wires from rubbing or shorting.
3.jpg
3.jpg (98.84 KiB) Viewed 98 times
Refitted the 'plug'. Although more for looks than any practical use.
5.jpg
5.jpg (137.08 KiB) Viewed 98 times
Pushed the pump terminals onto the module pins.
Slide the plug body over the top for appearances.
4.jpg
A month later and it all still seems to work fine.

Was a fun job :/



Post Reply