Did you know? 🤔
Logged in users can get email notification of topic replies Log in or register (free).
Amazon Link Buy your stuff using this and it helps MVS!

Differences between a Turbo & Non-Turbo Volvo Instrument Cluster

Help, Advice, Owners' Discussion and DIY Tutorials on all Volvo's "mid era" rear wheel drive Volvos.

1975 - 1993 240
1983 - 1992 740
1982 - 1991 760
1986 - 1991 780
1990 - 1998 940
1990 - 1998 960
1997 - 1998 V90/S90

maxbarkly
Posts: 3
Joined: Thu Jan 03, 2019 7:35 am
Year and Model: 1994 960 Wagon
Location: NY
Has thanked: 1 time
Been thanked: 0
United States of America
maxbarkly

Differences between a Turbo & Non-Turbo Volvo Instrument Cluster

Post by maxbarkly » Mon Jul 29, 2019 10:21 am

Hey folks,

I wanna get a sanity check before I make a purchase here. I have had consistent troubles with my instrument cluster in my 1994 960 Wagon. I am currently using a cluster pulled from a 1991 something-or-whatever that doesnt have a working speedo or clock (though i knew this to be the case for this model year)

I have finally found a working one on eBay right now, but its for a Turbo model 1994 940. I have a lot of weariness when it comes to this instrument cluster fiasco because as outlined below, there are a ton of compatibility issues across models...and I can only use clusters made between 93 & 94 for the 940/960 and 740/760
https://www.volvoclub.org.uk/faq/Electr ... bility.htm

So if my understanding of the cluster is correct....the Turbo gauge's existence should not effect anything regarding any other instruments and will not mess with the ECU/TCU unit. Its just not going to read any pressure because its not sending anything...will it throw an error without being hooked up to anything or just will it sit there?

If I end up getting this I might have to put a turbo on my b6304, which I hear is not recommended :?



lummert
Posts: 1307
Joined: Tue Jan 29, 2008 5:39 pm
Year and Model: 760 1988
Location: Portland Indiana, USA
Has thanked: 0
Been thanked: 12 times
United States of America
lummert

Re: Differences between a Turbo & Non-Turbo Volvo Instrument Cluster

Post by lummert » Mon Jul 29, 2019 5:22 pm

The boost gauge would work on the vacuum side if connected to intake manifold vacuum. You could look up the instrument cluster individual part numbers on one of the volvo parts sites. See what gauges and printed circuit part numbers are the same.


1988 Volvo 760 Turbo Wagon

jimmy57
Posts: 6298
Joined: Fri Nov 12, 2010 9:25 am
Year and Model: 2004 V70R GT, et al
Location: Ponder Texas
Has thanked: 2 times
Been thanked: 154 times
jimmy57

Re: Differences between a Turbo & Non-Turbo Volvo Instrument Cluster

Post by jimmy57 » Mon Jul 29, 2019 7:08 pm

The 960 uses Motronic and those others useLH Jetronic and EZK ignition. The Motronic on 92-95 960 communicates tachometer info as a serial signal and the 4 cylinder car lines did a simple digital signal. 96 and later 960/s90/v90 communicate temp gauge and tachometer as serial signal. The point is the clusters may look alike but are not interchangeable



Post Reply