IPD sale XeMODeX - Experts in Volvo Electronics

Get email notification of topic replies. Log in or register (free). Amazon Link Buy anything with this and it helps MVS!

PCV glove test not pulling or blowing

Help, Advice, Owners' Discussion and DIY Tutorials on Volvo's stylish, distinctive "P2" platform cars.

2001 - 2007 V70
2004 - 2007 V70 R
2001 - 2007 XC-70
2001 - 2009 S60
2003 - 2007 S60 R

Post Reply
Nathan79
Posts: 23
Joined: Thu Dec 28, 2017 12:41 am
Year and Model: 07 XC70
Location: Colorado
Has thanked: 1 time
Been thanked: 4 times

PCV glove test not pulling or blowing

Post by Nathan79 »

I've searched a bit on here but couldn't find exact issue & remedy. Here it goes.

05 xc70 185k:
Was idling sloppy & running with less power, showing code p0101... Since I knew a MAF replacement was immanent, I also did a glove test for pcv & found that there wasn't negative OR positive crankcase ventilation. After removing manifold & checking pcv hoses/ports/trap box & finding nothing more than oldish crackly vacuum hoses (yes, I replaced them)(yes, even the little infamous banjo bolt hose). Sooooo...I was left scratching my head & just Ended up replacing the maf. Smooth idle WITH power is back to satisfactory, (but boost doesn't seem to be optimal)(could just be me) ... And still the glove test result is "neutral"... No blowing or suction @ oil filler spout😔.

1. Does there even need to be suction @ oil filler spout @ idle?
2. You don't suppose it's the oil pick up tube in the oil pan do you, maybe ptc or boost solenoid?
3. If anything, What should I look for or try next?

Thanks
Nathan
User avatar
abscate
MVS Moderator
Posts: 22598
Joined: Sun Feb 17, 2013 5:54 pm
Year and Model: 99T5 ,99S70,2005V70
Location: NYC, ALBANY NY
Has thanked: 378 times
Been thanked: 1185 times

Re: PCV glove test not pulling or blowing

Post by abscate »

Try giving it some revs - like 2000-3000 and see if it pulls in. If it is limp at idle, but suction on revs, I think you are okay.
Empty Nester
A Captain in a Sea of Estrogen
1999-V70-T5M56 2005-V70-M56 1999-S70 VW T4 BMW
Link to Maintenance record thread
Link To Volvo Glossary
User avatar
oragex
Posts: 5027
Joined: Fri May 24, 2013 6:20 am
Year and Model: S60 2003
Location: Canada
Has thanked: 99 times
Been thanked: 297 times
Contact:

Re: PCV glove test not pulling or blowing

Post by oragex »

This is on a non turbo at idle - jump at 1:50 - www.youtube.com/watch?v=gS3bawaBMMk
not sure if the turbo is the same. But before I replaced the PCV, it was slightly blowing - now it sucks in with force
User avatar
vtl
Posts: 1952
Joined: Thu Aug 16, 2012 1:35 pm
Year and Model: 2005 XC70
Location: Boston
Has thanked: 3 times
Been thanked: 75 times

Re: PCV glove test not pulling or blowing

Post by vtl »

It should suck a lot while idling, since the vacuum goes through the inlet manifold, which has a lot of vacuum when not under the boost.

Revving to 2k does little, since the ECU knows it's in parking, and the turbo is not developing any boost. To check that "under boost" PCV contour, which clogs more easily, you need to step on the brakes, switch to drive and raise revs to 2-2.5k for a couple of seconds. Somebody outside should watch for the glove. It's not good for the transmission, so do it quickly.

Assuredly healthy PCV (new...) and still not much vacuum in crankcase would indicate a lot of blow-by gases, meaning compression rings are worn or stuck. Carry out a compression test.
05 XC70 265k, 16 XC60 45k, 19 Tundra 5k
Post Reply
  • Similar Topics
    Replies
    Views
    Last post