About time I get the adapter I guess... Will look into the app too. Thanks for the suggestions. Also for the documents! Thanks a lot. Is it fair to assume that Motronik4.4 and Fenix 5.2 ECM pinout matches at least to a large extent? Have a great weekend y'all! Large yes.. but you then missing examp...

Sorry message flew under my radar which not been functioning so well lately. I try share later when i improve it so its shareable as i want make it better still but at moment using the one from github as main source frame. hi Can you share your own Arduino code as an example? I could not get a sign...

Large yes.. but you then missing example second Lambda sensor and MAF on 10V engines if try install M4.4. I want share couple things as i have personally Fenix and 10V too. -No, there is no ECM hack existing to tell it not to look IMMO (Fenix 5.2.. all is for Fenix 5.1 or other models and yes i tri...

Your radio is turned too low. You start hearing sounds you dont like.

Update—phoned the prior owner on a whim and apparently their fob turned up after being missing for ages. Back up and running with 1 key + 1 fob—by the sounds of it, may cost a few hundred to get a 2nd proper set As this is long running question i now made personal example how program or register th...

https://youtu.be/Y0tRIfbx8k0 Started like from under palm tree! 20240927_180823.jpg https://media3.giphy.com/media/v1.Y2lkPTc5MGI3NjExMHg2dHRmdG11a3Z1ZGJoeXJ0ZnphcTFtNzVkeTJ1a3BmYXl4NzhteCZlcD12MV9pbnRlcm5hbF9naWZfYnlfaWQmY3Q9Zw/13d2jHlSlxklVe/200.webp 20240927_184941.jpg And after years mumbling th...

Measure your scanner OBD Pin pairs 6 & 14 3 & 11 Each pair should not have lower than 120kOhms if there is then yeah it can mess up some like that when connected it drops too much and loses connection. If scanner not have end resistor (can be better then) and shows much higher... i dont have...

Well the higher price is a kit so slightly over 10EUR piece. I am cheap and on 850 i recently went on cheapest Denso K20TT spark plugs. Technically slightly incorrect gap. But my problems of not starting in the end was at distributor being "gone" and rotary too inside it. My weared spark p...

I want just shortly share. Not all codes trigger MIL/Check Engine light. And Yes most likely fault code is related.

Picture got lost in bit space.

My 850 back on road after 5? months sitting finally. Got today Finnish MOT pass. Had to replace rear brake calibers as at MOT other side jammed and made very nice whining noise while driving back. Father was helping there as had cut the brake lines too to get old ones off. Sure on other side i made ...