You're weird!!!!! That is not coming from a place of judgement ,I'm only following instructions

(thats all I got)

I've heard a sound like that before coming from a solenoid near the throttle body

look at the dashboard the state of Mass posts every day. Number of deaths per day declining for over 10 days now, hospitalization peaked on april 22 or so https://www.mass.gov/doc/covid-19-dashboard-may-5-2020/download I see, you are considering Massachusetts, while I am thinking of across the enti...

ok so since the engine was unbolted i didn't try to reattach it to the subframe I just managed to unhook the steering shaft inside the car and sag the subframe way down low on the drivers side and took the passenger side subframe bolts almost all the way out. supported the subframe then lowered the ...

This is a nightmare now , it took me over 3 hours to get that all out and back in again . Hopefully its ok now. I realized during the process that I never explicitly pull that sunshaft out and none of the various videos show that either. I had a lot of trouble trying to get it together and I found t...

WOW !!

You were not kidding when you said clean! Looks brand new

It may be that there is so much to digest here that you have rendered folks speechless

I did make some pins to hold the gaskets. The rockauto kit came with metallic replacement gaskets for the channel plate . They were bent in 3 places and wouldn't lie flat so I was having trouble getting the gaskets to stay put. M6 threaded rod isn't a thing anywhere near me so I dug out 2 M6 bolts ,...

So today the side cover got back on! I needed to remove the front passenger subframe bolt completely though , even though the cover came off the way things were it would not go back on :roll: I bolted the subframe up where it goes , fought with the steering rack for over an hour because I undid both...

putting it all back together hitting a few snags . I had the owner order new brake hoses because the other ones were split and cracked at the caliper end. I put the new one on the drivers side and it looks too short when the wheel is cut to the left , its exactly the same length as the one that was ...