This car must mean a lot to you , and your Dad must as well ! It looks like it is ready to last another 20 years. In the midst of this transmission rebuild I'm doing its painful to see how sparkling clean it is under the hood of your car compared to the muck I have to scrape off :( These cars could ...

Well this is annoying I put 5 quarts in and it wont move and nothing on the stick yet, the walmart only had 6 on the shelf so when I put #6 in I was out and it still isn't showing on the stick but it went in reverse and drive! I can't test drive it though I seem to have no brakes. I had no one aroun...

I have a 98 S70 to part out here

It looks like the hose attached to the device in the second photo is near to failure. The hose diameter change at the end of the hose nipple is showing failure cracks. It would be good to replace now before it fails. Soap Box Rant Alert! Everyone attempting to service a modern vehicle should period...

You are on the right track to look at the position of the floor latch. I would loosen it up then figure out the best position then tighten it back up. Sometimes the latch needs to move in the opposite direction from what you might expect. Also check the little rubber bumpers located out at the side...

gas is funny stuff . I once drove my bronco all the way to new hampshire on a hot summer day and smelled gas when I arrived. Its a big V 8 with a carb huge flat intake manifold next to the carb is a large depression that held about 8 ounces of liquid gas merrily boiling from the heat of the engine. ...

what is the front of the trailer going to be made from? obvious answer the hatch from yet another volvo facing forward came to me after your idea reminded me of a project whichways truck that lived for 20 odd years here in plymouth mass. The owner grafted the front of a second truck backwards onto w...

BlackBart wrote: ↑30 Aug 2025, 15:31 My '04 P2 has cast alum control arms.

i forgot to mention it was the drivers side rear lower arm

I had a trick to get small screws out that works sometimes. An old timer showed me decades ago It sometimes requires sacrificing a socket though. I'd put a 6 point deep socket on the bleeder with a 1/4 inch drive ratchet . Then I fire up the 220 stick welder and touch the socket. You aren't trying t...

Another idea... After welding on the new front wall, I could design the structure inside to install a plexi window. BTW I already bought a nice set of 4 speakers for the trailer. 1 set of speakers to go. Kind of a horse before the cart thingamajig. I won't reveal anything about the speakers until t...