Not a rap fan, but this made me smile.
volvolugnut

Which ATF did you use? * This is fine or any other that's DEX III backwards compatible. Just flush till the old color changes to new. I will take a few photos next time but I used a turkey baster and pulled all the fluid out of the reservoir. I then removed the hose where the fluid returns to the r...

gnalan wrote: ↑17 Nov 2020, 14:50 Which ATF did you use?

Valvoline Dex 6 Synthetic

i think your meant to use CHF 11s fluid, thats what i used. I cant remember what brand it was but it wasnt volvo (think volvo use castrol oils, they put it in a container that says volvo and bam the price doubles).Also fairly sure volvo stopped recommending ATF on the P2 models?...i certainly wouldn...

How many quarts do I need to do a full flush and fill? (I prefer Castrol over Valvoline.) Which of the two videos posted above would be the better choice to get all of the old fluid out and replaced with new fluid? * Use the steering wheel method and attach the hose at the pump reservoir inlet hose...

That would be awesome! I don't know how many times driving I had to stop somewhere to use the bathroom. A built in flushable toilet for the driver's seat would be perfect. :D I read somewhere that some guys in Australia replaced the driver's seat in their Semis with a toilet loo. Pays for itself be...

I noticed I had a leak with my power steering system somewhere, since the rack has started groaning. I read on here about problems with the reservoir leaking, and also the plastic piece inside that connects to a brass piece coming off of the return line. My plastic piece is still connected, and the...

A aftermarket will not work unless it is designed as a replacement. The Siren is data controlled on the CAN BUS. You can try what others have done. Cut the case open and replace the battery then epoxy the case back together. It works if the battery has not leaked and ruined the Printed Circuit board.

Best is to get the new reservoir model off ebay, with the rubber hose attached - or from the junkyard May lift it, drain it, use a large towel to cover the engine. If you lift the coolant res, make sure to disconnect the sensor underneath The two are difficult to separate at the upper clip Takes onl...

I’ll see if I have a P2 style in my stash , too. I think they use the same As the late P80 1999-2000?