Just FYI, here's a good thread that discusses some of this.

ipd's modified turbo intake hose? has anybody tried it?
viewtopic.php?t=48893

Wouldn’t tinder be a natural place to hook up a smoke machine??

Smoke gets in your eyyyyes....

If you don’t orient the PTC orfice correctly On the snorkel the plug won’t reach. It faces forward when correct.

YAY! (like this?)

No puller needed for that rotor mounting plate. Remove the center bolt that screws into the camshaft (use a 10 mm socket) and then you should be able to pull it off with fingertips or just pry gently with a small screwdriver. It comes straight out. For the T5 exhaust cam rear seal here are some gene...

That plate will pop out. I think someone left an M6 off last time this job was done

Make match marks so you don’t spend three weeks with a crank, no start like me

I *think * it’s an M7 985135 , same as a cam cover screw , you could swipe one from the top to check fit and thread * gently*

What abscate said about the rear of the intake cam - there is no bolt in the center because it is missing. Plate pops right off. Hopefully the plate is not jammed on or epoxied on etc by a previous worker. Rear intake cam seal is the one most commonly and most easily replaced on these engines and cl...

The write up above, like all with content from cn90, Robb, Robert Spinner, and Erik, is excellent

Remember to correctly index the metal tabs on that plate to the end of the camshaft. It will go on both ways, but the car will not start if the plate is 180* off.