Try here: https://www.carparts.com/details/Volvo/S60/Behr/Heater_Core/2007/BEH15751003.html?TID=bngpla&origin=%7Badtype%7D&msclkid=462b8086a70b1095cdbae7355d72b28c&utm_source=bing&utm_medium=cpc&utm_campaign=BPM%20-%203PB%20-%20Catch%20All%20-%20Parts&utm_term=232526093490073...

If your friend’s 2013 is like our 2018 then he is correct - there is no dipstick. The fluid level is set by opening a stand tube that is in the center of the drain plug while it is idling in park (warm engine). In order to expose the fill port I had to move the air filter box out of the way. Don’t s...

“Just Maybe” it would help to remove the throttle body and the intake duct (the throttle body may need to be cleaned anyway) and “Just maybe” you can reach your right hand/arm under the intake manifold to disconnect/reconnect the hose from the top of the separator box.

Jrschwit, were you able to remove the old gasket in one piece? If so, lay it on a sheet of new gasket material and lightly spray over it with some spray paint which will leave a ghost image on the new material. Cut out the new gasket with an exacto knife, starting with the interior cut first. Then d...

“… now the fuel system will not pressure up for the normal 1-2 seconds when turning on ignition…”

Does the pump run once you start cranking the starter?

“….Fuel pump still works…”

Does it only run when you connect power directly to the pump?

Vova585: Yes, a ‘73 144E would be a D-Jet.

Macdnife: If you run power directly to the pump will the engine start?
Have you tried removing the fuses and cleaning their tips and contacts on the fuse block?

I’m assuming your car is the same as our 2018 with the Aisin 8-speed trans which uses the “WS” (World Standard) Mobil 3324 (vs 3309 in the P2’s). There is also an Aisin-labeled fluid you can use but it’s probably a bit more expensive. There is no external cooler in the radiator like the P2’s. Instea...

…..Probably could do a cooler return flush without a problem but up to you if you want to exchange it all. I believe the 2016 xc60 has the 8-speed trans which means there is no external cooler or associated hoses. The “cooler” is a small, finned gizmo on the front side of the trans not much larger ...

Assuming it’s misfiring on cylinder number 2…….
Swap the coil with cylinder number 1 and swap the spark plug with cylinder number 3. Clear the codes and then see what new code you get (P0301 or P0303)

Did you use Volvo/Bosch coils or another brand?
What plugs are you running?

I was able to swap in another used DIM on my 2003 V70, but the donor and receiver have to be of the same year PLUS certain code numbers on the back of the DIM have to match. In my case the donor DIM retained its original ( lower) mileage. Before removing your old DIM disconnect the battery and don’t...