Search found 620 matches
- 18 Nov 2022, 16:14
- Jump to forum
- Jump to topic
Re: 850 1995 Petrol 2,5 L 20S Exhaust manifold
I saved my old manifold with a failed flex coupling, thinking I might replace it someday. Getting the rotational alignment right seems a bit daunting. I suppose you could assemble the coupling to the cat and the manifold to the engine and then scribe an alignment line on the two parts. Chuck, did y...
- 20 Nov 2022, 01:54
- Jump to forum
- Jump to topic
Re: MVS Buddy Project
Mon ami,
Le 5 vous indique l'épaisseur du fil, le R la couleur
The 5 might be a mistake? That’s a very thick wire
Le 5 vous indique l'épaisseur du fil, le R la couleur
The 5 might be a mistake? That’s a very thick wire
- 23 Nov 2022, 22:57
- Jump to forum
- Jump to topic
Rehabilitating the T5M
I just purchased a 1998 V70 T5 manual (T5M) in Nautic Blue with 178k miles. This thread will document my work to rehabilitate it and its journey to (likely) becoming my daily driver. I drove a 2000 V70 NA manual for 18 years until it got rear ended and totaled (and stripped by abscate ). For the pas...
- 24 Nov 2022, 20:45
- Jump to forum
- Jump to topic
Re: Rehabilitating the T5M
Pretty good looking car, and running and driving to boot. Excellent job getting it home - even if it was two gulps. I lost my blue GLT to a timing belt idler failure, and was so disappointed, I couldn't bring myself to scrap it. It's sitting under the willow oak, slowly donating parts to its sibling...
- 26 Nov 2022, 10:36
- Jump to forum
- Jump to topic
Re: MVS Buddy Project
^ Most likely due to that disconnected hose. Are all of the ports on the vacuum tree utilized or capped ? That rubber piece looks like a coupling for hard vacuum line, so look and see if there is another loose end of that type of line anywhere in that area.
- 26 Nov 2022, 11:04
- Jump to forum
- Jump to topic
Re: MVS Buddy Project
Well I've never seen that light, but it's the Lambda symbol, so I'm guessing something to do with O2 system. And that hose might belong on your vacuum tree. It kind of looks like you have an open port on it in the picture pointing at the idle air control hose, but hard to tell. And the idle air con...
- 26 Nov 2022, 11:47
- Jump to forum
- Jump to topic
Re: MVS Buddy Project
LH Jetronic management should have EGR. Mine is M 4.4. That actuator which is near distributor on your car is at fan shroud on mine and it's part of SAS system which your car doesn't have . No.13 on that diagram should be EGR...actuator(i.e square cube) should be electronic control for the EGR and t...
- 26 Nov 2022, 18:09
- Jump to forum
- Jump to topic
Re: MVS Buddy Project
Exhaust gas recirculating on EU models. I don’t think it ever was on North American models. Not to be confused with Supplemental Air System thst was worldwide. Sas..pumps air into the exhaust manifold to ignite and burn excess fuel on cold starts EGR…recirculates exhaust gas to replace 10% of the co...
- 27 Nov 2022, 14:42
- Jump to forum
- Jump to topic
Re: MVS Buddy Project
What part are you looking for? If it is #13 which is part of the cruise control, I think that is by either your gas pedal or clutch/brake pedal under the dashboard. If I recall there is something up there in the older P80's. That actual pump that operates the cruise control used to be mounted under ...
- 27 Nov 2022, 14:44
- Jump to forum
- Jump to topic
Re: MVS Buddy Project
I hate to give up but it is way easier to fix when you are beside the car than from 6000km away and making best guesses. In the last picture on this thread there is a random white plastic pipe with a black rubber end on it near the red arrow end at the edge of the picture. It looks like it may go to...






