6 years and 70k miles with CD, no problems.

Yeah, same experience with the look of CD. But no problem in 6 years/70k and counting

02V70 wrote: ↑09 Sep 2023, 19:52 If I buy one of those plastic splash guards that were originally on the Volvo, would that potentially save my oil pan from another hole?

Buy IPD aluminum skid plate.

Need a new harness: https://www.fcpeuro.com/products/volvo- ... o-30798596

https://f01.justanswer.com/Eclayton4/d1 ... module.pdf

I think it is for plastic tank. Metal tank in NY? Was the car brought from CA?

Hook up DiCE/VIDA, start bleeding a caliper (with a vacuum pistol type pump), trigger ABS inlet/outlet valves of that caliper. You'll see a large air bubble escaping eventually.

TonyToronto wrote: ↑15 Oct 2023, 20:59 Hi everyone, after reading about 250 pages on this topic, I think I'm ready to give Teensy project a try. As far can transceivers to order, which are better Texas Instruments or Bosch ones?
Thank You

Any.

TonyToronto wrote: ↑15 Oct 2023, 20:55 Hi, does anyone have or know where to get the pin decoder software mentioned above? I can't find it at Digital-Kaos. Thank You.

It loads the CEM flash dump and reads the PIN at fixed offset. You can find the pin yourself if you have a dump.

Matuuu wrote: ↑16 Oct 2023, 05:38 Where to buy Teensy in Europe?
Cant find correct can transceiver also.
Is it need to be like board or enought to have only chip?
Thanks.

amazon.de?

Chip is fine, if you can solder a PCB.

Here's a pin from 2005 XC70 dump (327680 bytes), at offset 0x4E000: 1.png Thank you. Address 0x4E000 blank, all FF's. This CEM has MC32 MCU, can't seem to find the location for those. I used Autel programmer, VVDI failing to read this mcu. I have feeling it doesn't do a complete read. I've read 2 d...