THis is classic right wing propaganda, sorry The clip puts on an m-RNA researcher talking about Public Health Policy, not her field of expertise, and two people who have been 'injured by the vaccine' and their experiences with a preface that this isnt a 'biased view' Request to all Lets move this TO...

Where’s the electrical on that? Does it push in the pin on the electrical part of the switch? There are no electricals on the tumbler assembly Scrubbing bad information from the internet. Inserting the key pushes a plunger on the key tumbler which pushes in a pin on the ignition switch electrical p...

How’s that engine turning, lovemy850?

Planck , 1900 was the first to realize that quantum theory solved three problems classical physics couldn’t ( line spectrum of the sun, the photoelectric effect, and the ultraviolet catastrophe of black body radiation) but 24 years later it was the Frenchman DeBroglie who proposed that we exist in a...

That’s a horrible rabbit hole on the 2/76 module. One way around it is to ground the 85 terminal on the starter relay directly to a chassis ground with wire surgery The four relays in the kidney fuse box are , from left side of car to right Main engine Air pump ( usually empty on 99-00) Starter rela...

You have to depreciate the Volvo parts in Kroner and the Land Rover parts in GBP, and hedge the exchange rates on both, offering the result as a derivatived security on Wall street. I would short it like game Stop too.

Im going off the see if my spark plug GAAPS are set correctly.

Very early look at the data comparing a dull reflector , a 3m taped reflector , and a new TYC LAMP. all measurements with same battery and bulb. Exposure on integrated aperture priority , shutter speeds indicate approximate light out out was 25% dull 75% taped 100% reference TYC Conclusion. You can ...

I’ve documented both the turn in dash light sequence and the clutch switch measurements in this forum for the ME7 1999,2000 cars. I’ll try to find links and post up

I have a spare old timing belt just for that purpose. You could set it up and turn the engine over to listen for broken stuff. It’s rare to break pistons, just bent valves.



Either way, head comes off to rework, so I think that’s next step

Hey all. I had a 2001 XC70 that died on the way to the interior of BC. Lost oil pressure in the middle of nowhere and had to limp it in-car was toast, and many miles away from home so I had to let it go. After this experience I searched and found out the oil pickup tube likes to get clogged up. Pre...