Thanks Chuck. OK, will use rev_5b. What's the difference between the two? I noticed the rev_6 has launch control. Is rev_6 the latest version? How do I delete the rear O2. I don't see it under the Disable Diagnostics section. From the thread. As I recall the rev6 was experimental and I would not re...

In TunerPro, 1 is on/enabled and 0 is off/disabled.

For the grounds you have it right it is any one of them. Just pick one, they are all the same ground.

I use a single 14V power-supply for my bench flashing. I connect the B8 to the save power source as the power pins.

You want 13.5V + on the bootloader pin to enable flashing.

The only way I know of to check the TF-80SC fluid level is by using the level plug. Raise the car make sure it is level, start the car, hook up VIDA (or your Android app) and get the fluid up to 50 ˚C, pull the center plug. If you get drainage then it was overfilled. If you don't it was underfilled....

Not sure about the clutch plates, but I was going to say the clutch/throw out bearing or shaft might need lubed. Grease will dry out even when not used unfortunately.

Neil.

Is your accelerometer missing? Not sure why you need to add any of that stuff, however. The car should already have an accelerometer and a baro sensor. The IAT is not needed. When I did the initial M4.4 conversion on my '97 T5, I set the injector calibrations, disabled the rear O2 stuff, disabled th...

maybe look at this.

another option.

https://www.amazon.com/Mishimoto-MMOC-F ... merReviews