My friend and I hauled a bunch of Mercedes parts from Volvolugnuts place in Oklahoma to Connecticut. 2 bumpers, 2 doors, 1 fender, 1 trunk lid, 1 rear window, a lot of misc. stuff plus tools and luggage for the 3600 mile trip

I little bit of down ward pressure against the carpet helps remove these, I think maybe use the eBay pictures to visualize the connectors /

My wagon awaiting an engine had started its life as a window cleaning vehicle. It apparently had a large water tank in the trunk and ladders on it at all times. I used it as a work truck for my job and hauled a full load of tools with a roof top box also full. I’ve put 300 pound HVAC compressors in ...

In 2014, i let my flat, to move my little family and all furniture to the new one, 250 meters far. Cough on the rails, everything in the back excepted the fridge, which traveled on a 4 wheels wood plate. My wife, my children and i were poor at this time. We didn't need anything to be happy. My "...

Hospital cases are up 100% vs last year. It’s a bad one. Get the jab.

Ha it's still there https://www.zillow.com/homedetails/121- ... ?mmlb=g,19

I put in the bathroom pedestal sink and the fireplace tile also, and those are still there.

It was a tight fit, but I managed to squeeze a whole other wagon in the back of mine.

Happy to say that while likely temporary, the backflush of the AW55 was successful, the transmission pump is no longer whining with low temps. I highly recommend this if you cannot change the filter for one reason or another.

Happy to say that while likely temporary, the backflush of the AW55 was successful, the transmission pump is no longer whining with low temps. I highly recommend this if you cannot change the filter for one reason or another. . Can you provide the procedure and or equipment to back flush the transm...

Fixed. Cold wet garage floor was fun. There’s about 3” of clearance between the bottom of the pan and the subframe. You can get your hand up there, but hard to rotate it or thread the sensor in blind. It’s somewhere around 23mm, which of course I don’t have. No way a deep socket and ratchet would fi...