Hi guys, I just took the diagnostic below from my son's car: https://www.mediafire.com/convkey/157d/z57c56mkts35k4c4g.jpg At this time, I am only interested in the ECM-434C error, the BCM one is old and I know where it is coming from, but the ECM-614B is new, like the ECM-434C and I am not sure if t...

Hi All, Thank you for your feedback. To answer some of your questions, yes there is oil in the motor and no I did not switch to synthetics recently, I have always used the same oil. The ECM-439C error is related to the evaporative system, the Leak Detection Pump so it has nothing to do with the oil ...

Hi folks, I just wanted to report that after having cleaned the oil sump and I mean, clean as a whistle, replaced the oil pressure sensor, the PCV Nipple and cleaned all the filters, the car is driving very well, it feels like there is more power and there are no VIDA errors. It has been hard work, ...

RickHaleParker wrote: ↑27 Oct 2019, 14:08 Trace the paths. Look for loose screws, cracked printed circuits and defective solder joints. Any of which can open and close with thermal expansion.

Hi there,

It was a defective solder under the rheostat, I have redone all the soldering and everything works as new.

Thank you,
Alex

scot850 wrote: ↑09 Nov 2025, 05:53 Not sure if Erie Vo-Vo is an option for you down in New York area. Shipping might be a bear.

Neil.

I Neil,

Erie is one of the main suppliers for me, they have nothing on the internet, as far as I have seen, but I can call them tomorrow.